- New
-
PRODUCTS
-
ENGINE & PERFORMANCE
-
ENGINE COMPONENTS
- PISTONS
- CON RODS
- CRANK SHAFTS
- BUILT SHORT MOTORS & BARE BLOCKS
- STROKER KITS & LONG ROD KITS
- CAMSHAFTS & CYLINDER HEAD PARTS
- ENGINE BEARINGS
- BOLTS, STUDS & HARDWARE
- GASKETS & SEALS
- PULLEYS & DAMPERS
- ENGINE MOUNTS
- OIL PUMPS, OIL SYSTEMS & DRY SUMPS
- BELTS & TIMING ACCESSORIES
- OEM ELECTRICALS & SENSORS
- OEM ENGINE PARTS
- ENGINE REBUILD TOOLS
- TURBO CHARGES & TURBO SYSTEMS
- EXHAUST SYSTEMS & MANIFOLDS
- INTAKE & INDUCTION
- INTERCOOLERS & KITS
- BLOW OFF VALVES
- FUEL SYSTEM
- ENGINE COOLING & HEAT MANAGEMENT
- ENGINE ELECTRICAL & SENSORS
- IGNITION COMPONENTS
- BATTERIES & POWER SUPPLY
- ENGINE ACCESSORIES & DRESS UP
-
ENGINE COMPONENTS
- BRAKES
- CHASSIS & SUSPENSION
-
TRANSMISSION & DRIVETRAIN
- CLUTCH KITS & ACCESSORIES
- FLYWHEELS
- GEARBOX
- TRANSFER BOX
- PROP SHAFT
- REAR DIFFERENTIAL
- DRIVE SHAFTS / AXLES
- COMPETITION DIFFERENTIALS
- BOLTS & HARDWARE
- TRANSMISSION MOUNTS
- UPRATED DRIVETRAIN COMPONENTS
- SHORT SHIFTERS & SEQUENTIAL SHIFTERS
- DRIVETRAIN ACCESSORIES
- GEAR CABLES & SHIFTER BUSHINGS
- SHIFT KNOBS
- AYC PUMPS & COMPONENTS
- OILS & SERVICE ITEMS
- CAR CARE
- ELECTRONICS & GAUGES
- INTERIOR
- SAFETY
- EXTERIOR
- WHEELS & TYRES
- USED PARTS
-
ENGINE & PERFORMANCE
- About us
KING HIGH PERFORMANCE TRI-METAL COPPER LEAD CONROD BEARING O/S 0.25mm, MITSUBISHI LANCER EVO 4G63
HKD0.00
No tax
Bearing size inches 0.010”
Bearing size metric 0.25mm
Crankshaft undersize -0.010”
Additional shell thickness (on nominal) +0.005”
CR4120XP-0.25
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.
Your review cannot be sent
Bearing size inches 0.010”
Bearing size metric 0.25mm
Crankshaft undersize -0.010”
Additional shell thickness (on nominal) +0.005”